Icom IC-F9011 User Manual page 45

3Push [Digital Button] again to enter the Status
Message selection mode Message selection mode.
• A pre-programmed Status Message is displayed.
4Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired Message.
▒ While in the Trunking mode, the following steps
▒ 5 and 6 are not necessary. Go to step 7.
5Push [Digital Button] (or [Digital Status]) again to
enter the Individual ID selection mode enter the Individual ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
6Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] (or [Digital Status])
for 1 sec to cancel and return to normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key model only.
7Push [PTT] to transmit the Status Message to
the target station.
• The Busy/Transmit indicator lights red.
• "PLEASE WAIT" is displayed.
8Release [PTT]. 8Release [PTT].
• "ACK RECEIVED" is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• "NO ACKNOWLDG" is displayed when an
acknowledgement is not received, and then the
transceiver returns to normal operation.
APCO P25 Mode Operation
Receiving
▒ ▒ Not available on Non-display model.
1When a Status Message is received;
• The Busy/Transmit indicator lights green.
• The ringer sounds.
(Depending on the pre-set value.)
• The calling station ID name (or code) and the
Status Message blinks.
2An acknowledgement is automatically 2An acknowledgement is automatically
transmitted.
• The Busy/Transmit indicator lights red.
3Push any key (except for [ ]) to stop the display
from blinking and return to normal operation.
■ Short Message
Transmitting
The transceiver can send one of up to 10 different
pre-programmed Short Messages.
[Digital Button] or [Digital Message] key
assignment is necessary to transmit the Short
Message.
▒ Not available on Non-display model.
✔ For Trunking mode operation: ✔ For Trunking mode operation
The Short Message can be sent only to a dispatcher
in the Trunking mode.
1Push [Digital Button] to enter the digital call
type selection mode.
▒ ✔ Quick access
▒ Push [Digital Message] to directly enter the
▒ ▒ Short Message selection mode. In this case,
▒ skip steps 2 and 3. Go to step 4.
2Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select "SHORT MSG."
The received message The received message
The calling station ID name
45