Icom IC-F9011 User Manual page 34

➣ Un-matched (or matched) CTCSS is received.
(Depending on the pre-set value.)
➣ Un-matched (or matched) NAC is received.*
(Depending on the pre-set value.)
➣ The selected channel is a 'receive only'
channel.
*Digital mode operation only.
• Time-out timer
Af After continuous transmission for the pre- i
programmed time period, the time-out timer is
activated, causing the transceiver to stop
transmitting.
• Penalty timer
Once the time-out timer is activated, transmission
is further inhibited for a period determined by the
penalty timer penalty timer.
■ User set mode
User set mode is accessed at power ON and allows
you to set seldom-changed settings. In this case you
can "customize" the transceiver operation to suit
your preferences and operating style.
▒ When o operate the Non displa model this ▒ When you operate the Non-display model, this
▒ function is not available.
Entering the user set mode:
While pushing and holding [I] and
[II], rotate [VOL] to turn the power ON.
•Turn power OFF in advance.
•SET MODE appears for
1 sec at power ON.
2 Push and hold [ ] to enter user
set mode.
3 Push [ ] several times to select the appropriate
item. Then push [
level/condition.
•Available set mode functions are
Backlight, LCD contrast, Beep,
Beep Level, Ringer Level, SQL Level, Beep Level Ringer Level SQL Level
AF Min Level, Mic Gain,
VOX Gain*1, VOX Delay*1,
Horn Battery Voltage, Signal
Moni, Lone Worker*2
and System info.
34
Basic Operation
i i f h
[VOL]
[I]/[II]
[ ]
] or [ ] to set the desired
[ ]
[ ]/[ ]
*1 : Appears only when the external VOX unit is 1 : Appears only when the external VOX unit is
connected.
*2 : This function is valid on the transceiver's
revision 1.3 or later.
4 Push and hold [ ] again to exit the user set
mode.
•Until power is turned OFF, [ ], [ ] and [ ] is
not activated as the assigned key function.
▒ NOTE : While in the user set mode, [ ], [ ]
▒ and [ ] are activated as described above
▒ regardless of the assigned key function.
▒ User set mode is also available using a
▒ programmable key. See
▒ Programmable to Keys, User Set Mode
■ Clock function
The transceiver indicates the current time and date
when [ Clock ] is pushed. And you can change the
indication format and time/date settings.
▒ This function is not available on a Non-display
▒ model ▒ model.
▒ When you use the transceiver for the first time,
▒ or after the transceiver has sat unused for
▒ a long time, make sure to check the date and
▒ time indication after turning the power ON.
▒ If the time and date are not correct, reset them.
◇Time and date indication d d i di
◇Ti
1Push [ Clock ] to indicate the current time and
date on the LCD.
•When the indication format is set to 12-hour,
"AM" or "PM" is indicated.
•The LCD indication returns to the stand-by
mode after 30 sec has passed with no
operation. operation
The time indication format (12-hour/24-hour)
Date indication format ( Y: Year, M: Month, D: Day )
2Push [Clock] again to return to the stand-by
mode.
g y
4-1-3 Functions
Key.
i
Time
Date