Icom IC-F9011 User Manual page 41

2Push [Digital Button] again to enter the Individual
ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
3Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] or [Digital Page]
for 1 sec to cancel and return to normal for 1 sec to cancel and return to normal
operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key model only.
4Push [PTT] to transmit the pager signal to the
target station.
• The Busy/Transmit indicator lights red. The Busy/Transmit indicator lights red.
• "PLEASE WAIT" is displayed.
5Release [PTT].
• "ACK RECEIVED" is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• "NO ACKNOWLDG" is displayed when an
acknowledgement is not received, and then
transceiver returns to normal operation.
Receiving
▒ Not available on Non-display model.
1 When a pager signal is received;
• The Busy/Transmit indicator lights green.
• The ringer sounds. (Depending on the pre-
setting.) tti )
• " " blinks. (Depending on the pre-set value.)
• "PAGE RECEIVD" and the calling station ID
(or name) blink.
APCO P25 Mode Operation
2An acknowledgement is automatically transmitted.
•The Busy/Transmit lights red.
3Push any key (except for [ ]) to stop the display
from blinking and return to normal operation.
■ Radio Inhibit function
Transmitting
A Radio Inhibit function allows you to send a signal
that will inhibit (stun or kill, depending on the pre-set
value) the target transceiver.
[Digital Button] key assignment is necessary to
transmit the radio inhibit signal.
▒ Not available on Non-display model in the
▒ Conventional P25.
✔ o ✔ For Trunking mode operation:
This function is available only for a dispatcher in the
Trunking mode.
1Push [Digital Button] to enter the digital call type
selection mode.
2Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select "RDO INHIBIT."
3Push [Digital Button] again to enter the Individual
ID selection mode. ID
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
4Push [CH Up] or [CH Down], or rotate [CH
Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] for 1 sec to
cancel and return to normal operation.
• The ID can be edited with the 10-keypad*. The ID can be edited with the 10 keypad .
(Depending on the pre-set value.)
*10-key model only.
g o e ope a o
l ti d
41