Icom IC-F9011 User Manual page 42

5Push [PTT] to transmit the radio inhibit signal to 5P h [PTT]
the target station.
• The Busy/Transmit indicator lights red.
• "PLEASE WAIT" is displayed.
6Release [PTT].
• "ACK RECEIVED" is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation then the transceiver returns to normal operation.
• "NO ACKNOWLDG" is displayed when an
acknowledgement is not received, and then
transceiver returns to normal operation.
Receiving
If a radio inhibit signal is received that matches
your Individual ID, you cannot receive or transmit
afterwards. (Depending on the pre-set value.) f d (D
1When a radio inhibit signal is received;
• The Busy/Transmit indicator lights green.
• The ringer sounds. (Depending on the pre-
setting.)
• "SORRY" (default) appears. (Simple and 10-
key models only)
2An acknowledgement is automatically
transmitted. i d
• The Busy/Transmit indicator does not light
because the radio inhibit is activated.
▒ NOTE: The transceiver will not be revived until
▒ one of the following operations is performed.
▒ (Depending on the presetting.)
▒ • Receiving a radio uninhibit signal.
▒ • Entering the user passcode. ▒ • Entering the user passcode
▒ When the decode action is set to "Kill," the
▒ cloning operation is necessary to revive.
■ Radio Uninhibit function
Transmitting
A Radio Uninhibit function allows you to send a
signal that will revive the inhibited transceiver signal that will revive the inhibited transceiver.
[Digital Button] key assignment is necessary to
transmit the radio uninhibit signal.
42
APCO P25 Mode Operation
i h di i hibi i
di h l
Not available on Non-display model in the Not available on Non display model in the
l
Conventional P25 mode.
✔ For Trunking mode operation:
This function is available only for a dispatcher in the
Trunking mode.
1Push [Digital Button] to enter the digital call type
selection mode.
2Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select "RDO UINHIBIT."
)
3Push [Digital Button] again to enter the Individual
ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed,
the ID code is displayed.
4Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] for 1 sec to cancel • Push and hold [Digital Button] for 1 sec to cancel
and return to normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key model only
5Push [PTT] to transmit the radio uninhibit signal to
the target station.
• The Busy/Transmit indicator lights red. The Busy/Transmit indicator lights red.
• "PLEASE WAIT" is displayed.
6Release [PTT].
• "ACK RECEIVED" is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• "NO ACKNOWLDG" is displayed when an
acknowledgement is not received, and then acknowledgement is not received and then
transceiver returns to normal operation.