Engine Oil Change - Honda FRC800 Owner's Manual

SERVICING YOUR TILLER

ENGINE OIL CHANGE

Drain the oil while the engine is warm to assure rapid and complete
draining.
1.Place a suitable container below the engine to catch the used oil, and
then remove the engine oil filler cap, drain plug, and sealing washer.
2.Allow the used oil to drain completely, and then reinstall the drain
plug and a new sealing washer. Tighten the plug securely.
Improper disposal of engine oil can be harmful to the environment. If
you change your own oil, please dispose of the used oil properly.
Put it in a sealed container and take it to a recycling center. Do not
throw it in the trash, pour it on the ground, or pour it down a drain.
3.With the tiller in a level position, fill with the recommended oil to the
outer edge of the oil filler hole (see page 35).
Running the engine with a low oil level is misuse and can cause
engine damage. This type of damage is not covered by the
Distributor's Limited Warranty.
4.Reinstall the engine oil filler cap securely.
DRAIN PLUG
34
OIL FILLER CAP
UPPER LIMIT