Table of Contents
Advertisement
SERVICING YOUR TILLER
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete draining.
1. Place a suitable container below the engine to catch the used oil, and then
remove the oil filler cap, drain plug, and sealing washer.
2. Allow the used oil to drain completely, and then reinstall the drain plug with a
new sealing washer. Tighten the plug securely.
DRAIN PLUG TIGHTENING TORQUE:
18 N·m (1.8 kgf·m)
SEALING WASHER
(Replace)
DRAIN PLUG
OIL FILLER CAP
Improper disposal of engine oil can be harmful to the environment. If you change
your own oil, please dispose of the used oil properly. Put it in a sealed container and
take it to a recycling center. Do not throw it in the trash, pour it on the ground, or
pour it down a drain.
3. With the tiller in a level position, fill with the recommended oil (see page 43)
to the upper limit.
Engine oil capacity: 0.6 L
42
UPPER LIMIT
LOWER LIMIT
Advertisement
Table of Contents
