Engine Oil Change - Honda FG400 Owner's Manual

SERVICING YOUR HONDA TILLER
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete draining.
1.
Place a suitable container below the engine to catch the used oil, then
remove the filler cap/dipstick, drain plug and sealing washer.
2. Allow the used oil to drain completely, then reinstall the drain plug and
sealing washer. Tighten the plug securely.
l x E i a
Improper disposal of engine oil can be harmful to the environment. If you
change your own oil, please dispose of the used oil properly. Put it in a
sealed container and take it to a recycling center. Do not discard it in a trash
bin or dump it on the ground.
3. With the tiller in a level position, fill to the outer edge of the oil filler hole
with the recommended oil (see page 29).
Oil Capacity:
0.61
US qt (0.58 4)
- 1
Running the engine with a low oil level can cause engine damage.
4.
Screw in the filler cap securely.
OIL FILLER CAP/DIPSTICK
NECK
-
DRAIN
11
UPPER LlMT
r - y
LOWER LlMT
30