Engine Oil Change - Honda FRC800 Owner's Manual

SERVICING YOUR TILLER
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete
draining.
1. Place a suitable container below the engine to catch the used oil,
then remove the engine oil filler cap/dipstick, drain plug and
sealing washer.
2. Allow the used oil to drain completely, then reinstall the drain plug
and sealing washer. Tighten the plug securely.
1
NOTICE
1
Improper disposal of engine oil can be harmful to the
environment, if you change your own oil, please dispose of the
used oil properly. Put it in a sealed container and take it to a
recycling center. Do not discard it in a trash bin or dump it on the
ground.
3. With the tiller in a level position, fill to the outer edge of the oil
filter hole with the recommended oil (see page 32).
Oil Capacity: 1.16 US qt (1.104)
p T i E C
Running the engine with a low oil level is misuse can cause engine
damage. This type of damage
i s
not covered b y the Distributors
Limited Warranty.
4. Screw in the engine oil filler cap/dipstick securely.
ENGINE OIL
FILLER CAP
L
i
UPPER LIMIT
~
LOWER LIMIT-
DRAIN PLUG
31