Black Box 16-Port Rackmount 10/100 Installation Manual page 71

Table 15-1: Frequently-used Server Commands, cont.
Command
DEFINE SERVICE
"name" option
DEFINE SERVICE
"name" option
INITIALIZE option
Option(s)
DLC {EN/DIS}
BANNER {EN/DIS}
BINARY {EN/DIS}
EOJ string
FORMFEED {EN/DIS} When Enabled, causes the Terminal Server to
POSTSCRIPT
{EN/DIS}
PSCONVERT {EN/DIS} When Enabled, causes the Terminal Server to
SOJ string
TCPPORT string
TELNETPORT string
DELAY num
CANCEL
FACTORY
NOBOOT
RELOAD
Description
Specifies which service will handle print
requests from DLC hosts. DLC can be enabled
on one service per Terminal Server.
When Enabled, causes the Terminal Server to
print a banner page before jobs.
When Enabled, the Terminal Server will not
process data passed through the service. This
characteristic should be enabled when printing
PCL data.
Causes the Terminal Server to send an end-of-
job string to the attached device after every job.
Enter an end string or the word none.
append a formfeed to the end of LPR print jobs.
When Enabled, causes the Terminal Server to
assume the attached device is a PostScript
device and act accordingly.
place a PostScript wrapper around each job.
Causes the Terminal Server to send a start-of-
job string to the attached device before every
job. Enter a start string or the word none.
Specifies a raw TCP listener socket for the ser-
vice. Enter a socket number (4000 to 4999) or
the word none.
Specifies a TCP listener socket for the service.
Unlike TCPport, this option performs Telnet
IAC interpretation on the data stream. Enter a
socket number (4000 to 4999) or the word none.
Schedules a reboot after num minutes. Enter a
value from 0 to 120.
Cancels an impending initialization.
Reboots the Terminal Server to its factory
default settings.
Forces the Terminal Server to stop in Boot Con-
figuration Mode rather than fully rebooting.
Forces the Terminal Server to download new
operational code and reprogram its flash-ROM.
65