7.2 LAT Host Troubleshooting
By default, the LAT error message codes on the host are not translated into text error
messages. If a LAT job fails and appears in the queue with an eight-digit hex result code,
the code can be translated by issuing the following commands:
$ SHOW QUEUE/FULL/ALL queue_name
(note the error code nnnnnnnn)
$ SET MESSAGE SYS$MESSAGE:NETWRKMSG.EXE
$ EXIT %Xnnnnnnnn
Table 7-1: Troubleshooting LAT Configurations Using a Port
Area to check
The specified node name matches the
Terminal Server node name
The specified port name matches the
port's name
38
Figure 7-4: Translating LAT Error Codes
Explanation
Use the Show Server command to verify.
Use the List Port 1 command to verify.