15: Frequently-used
Commands
This appendix lists some of the most frequently-used commands of the Multiport Device
Server command set. More information about the command set, including additional
options, can be found in the Device Server Reference Manual located on the CD-ROM.
15.1 Conventions
Please note the following before continuing:
Commands are divided into Server (general), Port, and Protocol sections. Within
each section, commands are listed alphabetically.
Commands may require privileged user status. Enter Set Privileged, then enter the
privileged password when prompted.
When you enter a Define (or Purge) command, you must reboot the Terminal Server
for the command to take effect. Alternately, you can issue several Set commands and
then a Save command to make the Set commands take effect without rebooting.
When the abbreviated syntax "{EN/DIS}" is shown, you must choose either En-
abled or Disabled to complete the command.
When 2 is shown as the port number, enter a single port number, a list of port num-
bers separated by commas, a range of port numbers separated by dashes, or the word
all.
62