Black Box 16-Port Rackmount 10/100 Installation Manual page 56

Flash
Help
Init 451
SET BOOTP {Enabled, Disabled} Enables or disables the sending of BOOTP que-
SET DHCP {Enabled, Disabled}
SET Hardware xx-xx-xx
SET IPAddress ip_address
SET Loadhost ip_address
SET RARP {Enabled, Disabled}
50
This command will force the Terminal Server
to download new operational code and reload it
into Flash ROM. This is necessary when a new
version of software is released and you wish to
upgrade your unit. If the server cannot down-
load the file, the code in Flash ROM will still be
usable.
Displays a one-page summary of available
commands and what they do.
Reboots the Terminal Server after it has been
configured. If the Terminal Server can find and
load the specified software loadfile, it will re-
start itself with full functionality. If the loadfile
is not found, the server will attempt to reload
continuously. If there is an error, or if the con-
sole's Return key is pressed, the Terminal
Server will re-enter the Boot Configuration
Program.
ries during the boot sequence. It is enabled by
default.
Enables or disables the sending of DHCP que-
ries during the boot sequence. It is enabled by
default.
Specifies the last three numbers of the server's
Ethernet address. The first three numbers will
be supplied automatically.
The Ethernet address should have been set at
the factory. Setting an incorrect address could
cause serious network problems.
Specifies this server's IP address. Uses the stan-
dard numeric format.
Specifies the host to attempt to load the file
from. The IP address should be in standard nu-
meric format (no text names are allowed).
Enables or disables the sending of RARP que-
ries during the boot sequence. It is enabled by
default.