Table of Contents
Advertisement
2.1.6 Wiring the Digital Input / Output
The 6-contact terminal block connector on the rear panel of IGS-20040MT is used for Digital Input and Digital Output. Please
follow the steps below to insert wire.
1.
The IGS-20040MT offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups and 5 and 6 are GND
(ground).
2.
Tighten the wire-clamp screws for preventing the wires from loosening.
Figure 2-5 Wiring the Redundant Power Inputs
1
2
3
DI0
DI1 DO0 DO1 GND GND
Figure 2-6 6-Pin Terminal Block DI / DO Wiring Input
28
User's Manual of IGS-20040MT
4
5
6
Advertisement
Table of Contents
