3. Wiring DC Power Inputs
The 6-contact terminal block connector on the rear panel of Managed Metro Switch
is used for two DC redundant power input. Please follow the steps below to insert
the power wires.
1. Insert positive / negative DC power wires into contacts 1 and 2 for DC POWER
1, or 5 and 6 for DC POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosening.
The wire gauge for the terminal block should be in the range
between 12 and 24 AWG.
Note
1
2
3
4
DC 1
Fault Alarm
+
-
5
6
DC 2
+
-
5