Table of Contents
Advertisement
West
The Solar Siren contains a sophisticated radio
receiver. However, reception of radio signals can be
affected by the presence of metallic objects within the
vicinity of the Solar Siren. It is therefore important to
mount the Solar Siren a minimum distance of 1m
away from any external or internal metalwork, (i.e.
drainpipes, gutters, radiators, mirrors etc).
Ensure that the position selected for the Solar Siren
is within effective range of the Control Panel, (refer to
"Testing the Control Panel & Remote Control").
Tamper
Switch
6 Volt 1.2Ahr
Rechargeable
Battery
9 Volt PP3
Initial Power-Up
Battery
Main Configuration
Switch (in SIREN
Position)
C.U.
SIREN
North
Avoid if
possible
South
Solar Panel
C.U.
SIREN
Siren
Inside view of Solar Siren
Installing the Solar Siren
1. Remove the fixing screw from the bottom edge of
the Solar Siren Siren housing and carefully hinge off
the front cover.
housed within the front cover.
East
2. Hold the mounting plate in position and mark the
positions of the four mounting holes (a spirit level
placed on the casing will ensure a perfect level).
Drill four 6mm holes and fit the wall plugs.
3. Fit the two 30mm fixing screws in the top holes
leaving approx. 10mm of the screw protruding.
4. Fit the top keyhole slots of the mounting plate over
the screw heads.
adjust the screws until they form a neat fit with the
mounting plate with minimal movement
5. Secure the mounting plate in position using the two
25mm fixing screws in the bottom fixing holes.
6. Ensure that the Siren's main configuration switch
on the LED Indicator board is set to "Siren".
Front Cover
Locating Tabs
Receiver
Aerial
DIP Switch
Cover
Printed Circuit
Board Enclosure
LED/Strobe PCB
15
ll electronic components are
djust the mounting plate and
7.5 Volt DC
Charging Adaptor
Input
Beep Disable Link
P2
P2
P3
P3
Siren Disable Link
P1
P1
Jamming
Detection Link
House Code
DIP Switches 1-8
Alarm Duration
DIP Switch 9
Advertisement
Table of Contents
