Fold - Océ imagePRESS C7010VPS series Technical Manual

Fold

Introduction
Folding is activated by the Fold page device parameter, as follows:
• 0: No folding
• 1: Fold at device deactivation, i.e. next changed pagedevice. (Not supported)
• 2: Fold per sub-set
Supported, depending on fold type.
• 3: Fold per sub-set
Supported, depending on fold type.
• 4: Fold after each sheet
In addition, OutputType must be set to Auto, or to any tray which supports folding.
Example
When folding is activated, the fold options can be specified in the FoldDetails dictionary:
/FoldDetails contains:
<<
/Type (int)
/FoldType (string)
/PrintInside (boolean)
/FoldMediaSize (array of 2 numbers)
>>
Type is set to 12.
FoldType and Fold
FoldType and Fold can be combined in the following ways:
/FoldType
(Half-fold)
(Parallel-fold)
(Tri-fold-in-1)
(Tri-fold-in-2)
(Tri-fold-out)
(Gate-fold)
(Z-fold)
PrintInside is optional and has a default value of false.
If FoldMediaSize is specified, only formats falling within the standard tolerance (5 points) of the
given size is folded. If not specified, all sheets are folded.
Multi-folding (folding several pages together) is specified by setting /Fold to 2 or 3, while sheet
folding is specified by setting /Fold to 4. A sheet that is to be folded is required as short edge
feed.
imagePRESS C7010VPS series v2.2
Multi fold
Possible
Not possible
Possible
Possible
Not possible
Not possible
Not possible
Chapter 5 - Adobe® PostScript® 3™
Fold
67