Océ imagePRESS C7010VPS series Technical Manual page 317

When output recovery is suppressed, the printer does not check if the output is correct after a
recovery. The host system and the operator are responsible for the recovery. This means that
the operator must indicate at the host where printing needs to resume.
• Face orientation
With this setting, the default face orientation of the requested finisher can be overruled per
setup.
NOTE
Mpt = millipoints = 1/72000 inch.
IPDS image shift settings
Image shift in feed direction of side 1
Image shift in cross-feed direction of
side 1
Image shift in feed direction of side 2
Image shift in cross-feed direction of
side 2
• The image shift in feed direction is the margin of the front edge and the back edge of the sheet.
The front edge and back edge are defined by the feed direction of the sheet. The image shift in
cross-feed direction is the margin of the side edges of the sheet. Side 1 is the front of a sheet.
Side 2 is the back of a sheet.
Colour management settings
Default CMYK input profile
Default monochrome CMYK input
profile
Default RGB input profile
Default monochrome RGB input pro-
file
Rendering intent
Print full colour or B/W
Ignore toner transfer curve from data
steam
Ignore embedded output profile
NOTE
PCL contains no embedded
output profiles.
Black preservation
Halftone
• Rendering intent
Use setting "Rendering intent" only when no render intent is defined in the data stream.
• Halftone
This setting defines the halftone pattern for text, graphics and images.
imagePRESS C7010VPS series v2.2
Range
0 mm is the default value.
Minimum: -4.2
Maximum: 4.2
Step: 0.1 mm
Range
For PDF and native IPDS data using DeviceCMYK. Input
profile or "none".
Input profile or "ibm" or "postscript".
For PDF and native IPDS data using DeviceRGB. Input
profile or "none".
Input profile or "none" or "ibm" or "postscript".
Perceptual (default), Saturation, Absolute colorimetric,
Relative colorimetric
Full colour (default), B/W
Yes (default), No
Yes (default), No
On (default), Off
Normal (default), Fine, Error diffusion
SRA IPDS settings
Chapter 14 - SRA IPDS 317