Océ imagePRESS C7010VPS series Technical Manual page 26

Automated Work Flows in the imagePRESS C7010VPS series
• The job completed time
• The trailer sheet generation time
• The actual number of sheets of each used media in the job. Each media is defined by its 10
selection attributes.
NOTE
The following media are not included in the actual number of used sheets:
banner page media
slip-sheet media
trailer media
The media used for the trailer is the same media as specified for the banner page.
Automated Work Flows in the imagePRESS C7010VPS series
Introduction
The PRISMAsync offers the possibility to print jobs via multiple print queues. You can create and
assign properties to the print queues. The properties are based upon specific workflow
requirements. Therefore, these queues are called Automated Work Flows (AWF). For each AWF,
the operator can define specific job settings, which are assigned to the jobs sent via the AWF.
The queues are accessible from the sending host. Each queue represents a different AWF.
You can create one or more AWFs in the Settings Editor in section 'Preferences'.
Default AWF
The imagePRESS C7010VPS series has one default queue. The default queue is the default AWF.
The default queue cannot be deleted.
Jobs are send to the default queue of the imagePRESS C7010VPS series, when:
• No queue is specified.
• A queue is specified, but the queue is not an AWF.
Adding a new AWF
You can create one or more AWFs in the Settings Editor in section 'Preferences'.
Each AWF must have a unique name. The AWF name can have a maximum of 25 characters. The
name is case sensitive and any Unicode character can be used.
You can create an unlimited amount of AWFs. However, the performance of the controller can be
reduced when you create more than 250 AWFs.
NOTE
The LPD queue name is used as the AWF name. However, it is possible that the two names are
not identical. Reason: The AWF name can be specified in Unicode, but the LPD queue names can
only be specified and accessed in ASCII on the sending host.
Operations on AWF
You can add, delete and rename AWF queues. You cannot rename or delete the default AWF
queue.
Attributes of the AWF
It depends on the software release which attributes you can use to create an AWF. You can find
the available attributes of the concerning software release in section 'Preferences' in the Settings
Editor.
AWF and socket printing
26 Chapter 2 - PRISMAsync
imagePRESS C7010VPS series v2.2