Wall-Mounting Instructions - ZyXEL Communications VMG892-B10A User Manual

Chapter 1 Introducing the Device
To activate WPS:
Make sure the PWR/SYS LED is on and not blinking.
1
Press the WPS button for five seconds and release it.
2
Press the WPS button on another WPS-enabled device within range of the Device. The WiFi 2.4G
3
LED flashes orange while the Device sets up a WPS connection with the other wireless device.
Once the connection is successfully made, the WiFi 2.4G LED shines green.
4
To turn off the wireless network, press the Wi-Fi button for one to five seconds. The WiFi 2.4G
LED turns off when the wireless network is off.

1.8 Wall-mounting Instructions

Do the following to hang your Device on a wall.
Locate a high position on a wall that is free of obstructions. Use a sturdy wall.
1
Hold the bracket against the wall and mark where to drill the holes.
2
Drill the two screw holes in the wall.
3
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Align and insert the bracket to the wall-mounting notches on the rear panel of the Device.
4
24
VMG8924-B10A and VMG8924-B30A Series User's Guide