The Applications Screen - ZyXEL Communications VMG892-B10A User Manual

Table 57 Port Forwarding: Add/Edit (continued)
LABEL
Start Port
End Port
Translation
Start Port
Translation End
Port
Server IP
Address
Protocol
Wake up this
target by Wake
On Lan(WOL)
MAC address of
WOL device
OK
Cancel

10.3 The Applications Screen

This screen provides a summary of all NAT applications and their configuration. In addition, this
screen allows you to create new applications and/or remove existing ones.
To access this screen, click Network Setting > NAT > Applications. The following screen
appears.
Figure 84 Network Setting > NAT > Applications
VMG8924-B10A and VMG8924-B30A Series User's Guide
DESCRIPTION
Enter the original destination port for the packets.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port field.
Enter the last port of the original destination port range.
To forward only one port, enter the port number in the Start Port field above and then
enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with the port
number in the Start Port field above.
This shows the port number to which you want the Device to translate the incoming port.
For a range of ports, enter the first number of the range to which you want the incoming
ports translated.
This shows the last port of the translated port range.
Enter the inside IP address of the virtual server here.
Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Select this and enter the MAC address of a LAN device if you want to turn the device on
remotely from the Internet or the WAN network using this port forwarding rule.
Enter the MAC address of the LAN device. A MAC address consists of six hexadecimal
character pairs.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
Chapter 10 Network Address Translation (NAT)
161