Add/Edit Address Mapping Rule - ZyXEL Communications VMG892-B10A User Manual

Chapter 10 Network Address Translation (NAT)
Table 64 Network Setting > NAT > Address Mapping (continued)
LABEL
Type
Modify

10.7.1 Add/Edit Address Mapping Rule

To add or edit an address mapping rule, click Add new rule or the rule's edit icon in the Address
Mapping screen to display the screen shown next.
Figure 92 Address Mapping: Add/Edit
The following table describes the fields in this screen.
Table 65 Address Mapping: Add/Edit
LABEL
Type
Local Start IP
Local End IP
Global Start IP
168
DESCRIPTION
This is the address mapping type.
One-to-One: This mode maps one local IP address to one global IP address. Note that port
numbers do not change for the One-to-one NAT mapping type.
Many-to-One: This mode maps multiple local IP addresses to one global IP address. This is
equivalent to SUA (i.e., PAT, port address translation), the Device's Single User Account
feature that previous routers supported only.
Many-to-Many: This mode maps multiple local IP addresses to shared global IP addresses.
Click the Edit icon to go to the screen where you can edit the address mapping rule.
Click the Delete icon to delete an existing address mapping rule. Note that subsequent
address mapping rules move up by one when you take this action.
DESCRIPTION
Choose the IP/port mapping type from one of the following.
One-to-One: This mode maps one local IP address to one global IP address. Note that port
numbers do not change for the One-to-one NAT mapping type.
Many-to-One: This mode maps multiple local IP addresses to one global IP address. This is
equivalent to SUA (i.e., PAT, port address translation), the Device's Single User Account
feature that previous routers supported only.
Many-to-Many: This mode maps multiple local IP addresses to shared global IP addresses.
Enter the starting Inside Local IP Address (ILA).
Enter the ending Inside Local IP Address (ILA). If the rule is for all local IP addresses, then
this field displays 0.0.0.0 as the Local Start IP address and 255.255.255.255 as the Local
End IP address. This field is blank for One-to-One mapping types.
Enter the starting Inside Global IP Address (IGA). Enter 0.0.0.0 here if you have a dynamic
IP address from your ISP. You can only do this for the Many-to-One mapping type.
VMG8924-B10A and VMG8924-B30A Series User's Guide