The 802.1X Screen - ZyXEL Communications VMG892-B10A User Manual

Chapter 5 Broadband
Table 11 Network Setting > Network Setting > Broadband (continued)
LABEL
PhyR DS
SRA
Apply
Cancel

5.5 The 802.1x Screen

You can view and configure the 802.1X authentication settings in the 802.1x screen. Click
Network Setting > Broadband > 802.1x to display the following screen.
Figure 29 Network Setting > Broadband > 802.1x
The following table describes the labels in this screen.
Table 12 Network Setting > Network Setting > 802.1x
LABEL
#
Status
Interface
EAP Identity
EAP method
Bidirectional
Authentication
Certificate
Trusted CA
Apply
Cancel
64
DESCRIPTION
Enable or disable PhyR DS (downstream) for downstream transmission from the WAN.
PhyR DS should be enabled if data being transmitted downstream is sensitive to noise.
However, enabling PhyR DS can decrease the DS line rate. Enabling or disabling PhyR will
require the CPE to retrain. For PhyR to function, the DSLAM must also support PhyR and
have it enabled.
Enable or disable Seamless Rate Adaption (SRA). Select Enable to have the Device
automatically adjust the connection's data rate according to line conditions without
interrupting service.
Click Apply to save your changes back to the Device.
Click Cancel to return to the previous configuration.
DESCRIPTION
This is the index number of the entry.
This field displays whether the authentication is active or not. A yellow bulb signifies that
this authentication is active. A gray bulb signifies that this authentication is not active.
This is the interface that uses the authentication. This displays N/A when there is no
interface assigned.
This shows the EAP identity of the authentication. This displays N/A when there is no EAP
identity assigned.
This shows the EAP method used in the authentication. This displays N/A when there is no
EAP method assigned.
This shows whether bidirectional authentication is allowed.
This shows the certificate used for this authentication. This displays N/A when there is no
certificate assigned.
This shows the Trusted CA used for this authentication. This displays N/A when there is no
Trusted CA assigned.
Click Apply to save your changes back to the Device.
Click Cancel to return to the previous configuration.
VMG8924-B10A and VMG8924-B30A Series User's Guide