Xerox Document Centre 400 series User Manual page 99

Menu Item Explanation
Duplex* Sets two-sided printing.
The candidate values are OFF and ON which includes Short Edge and Long Edge.
Default value is OFF.
Orientation Sets the orientation for printing for PCL 6 only.
The candidate values are Portrait and Landscape. Default is Portrait.
Form Lines Sets the page length (printing area) of one page.
The range of setting is between 5-128 lines with 1 line per unit. Default is 64.
Image Enhance Enables or disables image enhancement. Image enhancement is to raise the resolution and to
produce smooth print of sharp edges.
The candidate values are ON and OFF. Default is ON.
Economode Turns the Economode on and off.
The candidate values are OFF and ON. Default is OFF.
*optional
• The values set are changeable by commands.
• The setting takes on default value when the NVRam is initialized.
• BPT-supplied paper cannot be used for two-sided printing. Also, even if
Bypass Tray is set for Tray when two-sided printing is specified, the
printing will be in one-sided.
• Even if two-sided printing is specified, the printing result may be different
when the following settings are performed which cause insufficient memory:
(1) When Paper size (A3) and Resolution (600 dpi) are set, it will
first print as A3/600 dpi in two-sided. If this printing cannot be
done, it will print as A3/400 dpi in one-sided.
(2) When Paper size (A3) and Resolution (400 dpi) are set and if it
cannot be done, it will print as A3/400 dpi in one-sided.
In the above case, either terminate the state of the ports that are not being
used or install the additional RAM module.
• The values set are changeable by commands.
• The setting takes on default value when the NVRam is initialized.
• The values set are changeable by commands.
• The setting takes on default value when the NVRam is initialized.
• The values set are changeable by commands.
• The setting takes on default value when the NVRam is initialized.
• Economode causes the printer to use lesser amount of toner. As a result,
pages printed with Economode turned on will be lighter than pages printed
with Economode turned off.
• This feature can be used to print draft-quality documents so as to extend the
life of your toner cartridge.
• Economode will not affect the speed or performance of your printer.
• The setting takes on default value when the NVRam is initialized.
5.2 Mode Menu Items
87
5