Xerox Document Centre 400 series User Manual page 142

Appendix B Connector and Allocation Signals
Meaning of the signals
When the bidirectional is OFF:
• nStrobe(Pin No.1)
The synchronous signal for the reading of Data 1-8; needs the LOW active pulse.
• Data1-8(Pin No.2-9)
For the 8-bit parallel data input, Data 1 is LSB (lowest bit) and Data 8 is MSB (uppermost bit).
• nAck(Pin No.10)
A LOW active pulse signal which indicates that the received data has been taken in.
• Busy(Pin No.11)
A HIGH active signal which indicates that the printer is unable to receive data.
• PError(Pin No.12)
A HIGH active signal which indicates that there is no more paper.
• Select(Pin No.13)
A HIGH active signal which indicates that it is possible to receive data.
• nAutoFd(Pin No.14)
The signal when the bidirectional is ON.
• Chassic Gnd(Pin No.17)
Connected to frame ground.
• Peripheral Logic High(Pin No.18)
+5V voltage on the host side.
• Signal Ground(Pin No.19-30)
Connected to the various signal ground.
• nInit(Pin No.31)
The LOW active pulse signal which requests for the initialization of the printer.
• nFault(Pin No.32)
The LOW active signal which indicates that errors such as paper jams have occurred in the
printer.
• nSelectIn(Pin No.36)
The signal when the bidirectional is ON.
When the bidirectional is ON:
All connection adheres to the IEEE1284-C connector standard.
130