Display - Monitor - Eneo BLR-3004 Operation Instructions Manual

SYSTEM SETUP

DISPLAY - MONITOR

SEQUENCE DWELL : The amount of time that each screen is displayed in a sequence.
SPOT-OUT DWELL : The amount of time that each screen is displayed on each of the spot monitor outputs.
DE-INTERLACE MODE : When recording any channels in D1 resolution (704 x 480), this may be set to ON,
ALARM POP-UP MODE : When enabled, an alarm input will cause the associated channel to display full screen.
ALARM POP-UP DWELL : Determines the amount of time a full screen popup is displayed after an alarm input.
MOTION POP-UP MODE : When enabled, motion detection will cause the associated channel to display full screen.
MOTION POP-UP DWELL : Determines how long the full screen popup is displayed after motion detection.
To change any of these settings, highlight „MONITOR‟ and press „ENTER‟ to select.
Use the CURSOR KEYS to navigate to the option required.
Press ENTER to select the option (the cursor changes to orange) and use the CURSOR KEYS to change the setting.
Press ENTER to save the setting, or press RETURN to cancel.
NOTE: When display modes are changed, the DVR must be rebooted in order for changes to take effect.
to prevent interlaced motion distortion during playback.
If the alarm condition continues, the pop-up screen will be displayed constantly.
If motion continues, the popup screen is displayed constantly.
Click the MONITOR menu, then click on any field.
Use the button to modify the value.
24