Fuses - Arctic Cat 2008 400 4x4 Owner's Manual

! CAUTION
When replacing the headlight bulb, be careful not to touch the glass
portion of the bulb. Grasp the new bulb with a clean cloth.
Registration Plate Light
To replace the taillight bulb, use the
following procedure:
1. Remove the two screws and
2. Pull out the bulb.
3. Install the new bulb by
4. Install the lens. Tighten the
KM143B
Turning Light or Taillight/Brakelight
To replace the turning light or taillight/brakelight bulb, use the follo-
wing procedure:
1. Rotate the socket counterclockwise and remove it from the
housing.
2. To remove the bulb from the socket, push in and rotate
counterclockwise.
3. To install the bulb, push in and turn clockwise.
4. Insert the socket into the housing and rotate it clockwise.

FUSES

The main fuse is located under the
seat near the battery.
The fuses are located in a power
distribution module in front of the
steering post under the electrical
access panel. If there is any type
of electrical system failure, always
check the fuses fi rst.
n Note:
To remove the fuse, compress the locking tabs on either side of the
fuse cover and lift off; then remove and replace the fuse.
86
remove the lens.
pushing it in.
two screws securely.