Control Locations And Functions - Arctic Cat 2008 400 4x4 Owner's Manual

CONTROL LOCATIONS AND FUNKTIONS
Ignition Switch
The ignition switch has three positions.
OFF position - All electrical
circuits are off. The engine will not
start. The key can be removed in
this position.
ON position - The ignition circuit is
complete and the engine can run.
The key cannot be removed in
KM185
this position.
LIGHTS position - The ignition circuit is complete and the position
lights are on. The key cannot be removed in this position.
n Note:
To illuminate the headlight, the engine must be running and the
headlight switch must be in the HI or LO position.
! CAUTION
Leaving the ignition switch in the LIGHTS position for a long period
of time when the engine is not running may cause the battery to
discharge. Always leave the ignition switch in the OFF position
when engine is not running.
Indicator Lights
1. Turn Lights Left and Right
2. High Beam Indicator - A blue
1
1
3 2
3. Temperature Indicator - A red
KM176A
overheats. The light should be off during normal operation.
Liquid Crystal Display - LCD
1. Adjust Button - Used to toggle between Clock, Hour Meter,
Odometer, and Trip Meter in the display (5). In conjunction with
the Mode Button (2), sets the clock and resets the trip meter to
zero. Also used to toggle between MPH and km/h.
light will illuminate when the
engine is running, the ignition
switch is in the LIGHTS
position, and the headlight
switch is in the HI beam position.
light will illuminate if the engine
61