Arctic Cat 2008 400 4x4 Owner's Manual page 86

Headlight
n Note:
The bulb portion of the headlight is fragile. HANDLE WITH
CARE. When replacing the headlight bulb, do not touch the glass
portion of the bulb. If the glass is touched, it must be cleaned
with a dry cloth before installing. Skin oil residue on the bulb will
shorten the life of the bulb.
Headlight
Taillight/Brakelight
Turn Signal Front
Turn Signal Rear
Number Plate Light
! WARNING
Do not attempt to remove the bulb when it is hot. Severe burns may
result.
To replace the headlight bulb, use the following procedure:
1. Remove the rubber boot from
2. Release the end of the spring
3. Install the new bulb into the
4. Connect the three-wire connec-
12V/35W/35W
12V/5W/21W
12V/21W
12V/10W
12V/5W
the back of the headlight hou-
sing; then remove the three-
wire connector from the bulb.
clip from the headlight hous-
ing taking care not to bend
or deform the clip; then remove
the bulb from the housing.
housing; then secure with
the spring clip.
tor to the bulb; then install the
rubber boot.
85