Arctic Cat 2008 400 4x4 Owner's Manual page 63

n Note:
Pump the primer three times when the temperature is at 0° C (32° F)
or colder. To access the primer, the seat and right-side heat shield
must be removed.
2. Mode Button - Used to toggle between MPH and km/h in the dis
play (5) on the LCD. In conjunction with the Adjust/Set Button
(1), sets the clock or resets the trip meter to zero.
3. Gear Position Indicator - Indicates which gear position is selected.
R (reverse)/N (neutral)/L (low range)/H (high range).
n Note:
An E will be displayed if the transmission is not engaged in a selected
gear.
4. Speedometer - Indicates the approximate vehicle speed in miles
per hour (MPH) or kilometers per hour (km/h).
5. Clock/Hour Meter/Odometer/Trip Meter - Displays time, total
engine hours, total miles/kilometers traveled, or trip miles/
kilometers traveled. To set the
clock, use steps A-C. To reset the
trip meter, proceed to step D.
A. To set the clock, press and hold
3 4 5
the Adjust Button (2) until CLOCK
is displayed.
KM185
B. Press and hold the Adjust/Set
Button (1) and Mode Button (2) until
the hour display starts to fl ash (ap-
proximately three seconds); then
1 2
release the buttons and press the
Adjust Button (1) to set the hour.
KM185
Note:
n
The hour display will read from 1 to 24 and may be cycled rapidly by
holding the Mode Button (2) down for three seconds.
C. After the correct hour is attained, momentarily press the Mode
Button (2) to toggle the clock to the minute display (minutes fl ashing);
then press the Adjust Button (1) to set the minutes. After approxima-
tely ten seconds, the minute display will stop fl ashing and the gauge
will return to normal operation.
62