Tires - Arctic Cat 2008 400 4x4 Owner's Manual

DRAINING V-BELT COVER
n Note:
If the ATV has been driven through water, the V-belt cover must
be drained of any water.
1. Place the ATV on a level sur
2. Remove the drain bolt from the
3. Shift the range lever to the neu-
4. Increase and decrease engine RPM several times to "blow out"
any water; then stop the engine.
5. Install the drain bolt and tighten securely.
! WARNING
Always use the size and type of tires as specifi ed. Refer to the ap-
propriate specifi cations chart for proper tire infl ation pressure, and
always maintain proper tire infl ation pressure.

TIRES

Tire Tread Condition
The use of worn-out tires on an ATV
is very dangerous. A tire is considered
to be worn out when the depth of the
tread is less than 4 mm (5/32 in.). Be
sure to replace the tires before rea-
ching this minimum specifi cation.
! WARNING
The use of worn-out tires can be dangerous and can increase the
risk of an accident.
Tire Replacement
The ATV has low-pressure tubeless tires. Air is sealed by the contact
surfaces of the inner wheel rim and the tire bead. If either the inner
wheel rim or tire bead is damaged, air may leak. Be extremely careful
not to damage these areas when replacing tires.
It is very important to use the proper tools when repairing or repla-
cing tires to prevent damage to the tire bead or wheel rims. If proper
tools and related items are not available, have this
face.
cover and allow the water to
drain out.
tral position; then start the engine.
83