Oil Level; Seat Latch - Arctic Cat 2008 400 4x4 Owner's Manual

Oil Level Stick
There is an oil level stick for checking the engine oil level. to check the
oil level, use the following procedure.
n Note:
The ATV sould be on level ground when checking the engine oil
level.
1. Unscrew the oil level stick and wipe it with a clean cloth.
2. Install the oil level stick and thread it into the engine case.
3. Remove the oil level stick; the engine oil level should be above
the „L" mark but not higher than the „F" mark.
! CAUTION
Do not overfi ll the engine with oil. Always make sure the oil level is
above the "L" mark but nor higher than the "F" mark.

SEAT LATCH

1. To remove the seat, lift up on
2. To lock the seat into position,
fi rmly on rear of seat. The seat should automatically lock into position.
! WARNING
Make sure the seat is secure before mounting the ATV. Severe per-
sonal injury may result if the seat is not properly secured.
the latch release (located at the
rear of the seat); then raise the
rear of the seat and slide it rear-
ward.
slide the front of the seat into
the seat retainer and push down
67