Automatic Hold - Comdial DX-80 Installation And Maintenance Manual

¢£¤¥
•
Use
and "TO" for each day of the week and for the switch modes Alternate and Evening. (It is also split into the
three groups for each of the Tenant Groups.)
«
•
Press .
•
Input the time when this service mode should become active in the left column and when it should stop
being active in the right column. When the time has been input, press
•
When you have completed all changes, press the
screen. You will see the prompt: "Exit This Feature"; press "Y" for yes.
•
You will then be prompted to "Save Current Setting?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" to save changes.
•
If you press "Y" (yes), you will then be prompted "File Exists, Override?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" (yes) to continue with the save operation.
°
•
Press (escape) again to return to the Database Programming menu.
•
Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a "SEND" function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.

Automatic Hold

You may enable this feature on your telephone to simplify call handling and avoid accidental "lost" calls. Automatic
Hold will automatically place any call that is currently connected at your telephone on hold whenever a CO line button
is pressed. For instance, if you are currently on a call on line 1 and you press line 2, the call on line 1 will be placed
on Exclusive Hold automatically. Similarly, if you are currently on an intercom call and talking with another DX-80
extension then press a CO line button, the intercom call will be placed on Exclusive Hold. The need to press Hold is
eliminated, unless you want to place a call on System Hold.
Related Features
CO Line Group
Related Programming
Call Handling - Hold Reminder, Hold Recall
Operation – Setup
!94
1. Press
2. You hear the confirmation tone and the condition is set. The display shows:
3. The extension is returned to an idle state.
Operation – Auto Hold (enabled)
1. While connected to a call (intercom or CO Line). Press another CO Line button.
2. The current connection is placed on hold and then next connection is established.
P7290 IMM
DX-80 I
NSTALLATION AND
to highlight Service Mode for which a time must be input. This screen is read as "FROM'
.
AUTO HOLD ALLOW
M M
AINTENANCE ANUAL
«
°
(escape) key to exit this database-programming
Exclusive Hold
3-26
to store.
!94