Moog Videolarm IP Ready IFDW75CN Product Instructions page 8

installing the axis 231D/232D Camera (cont.)
7. Housing with 2685 mounting plate installed.
8. Since the 231D/232D camera operates on 24vac, the power
board that is located inside the housing is not needed. The
remove the power board, start by loosening the screws
on the terminal block and disconnect the orange and red
wires.
9. With a Phillips head screwdriver remove the (4) machine
screws holding the power board to the base bracket.
10. Locate the connector
block, which is included
with the camera. Then
locate the connector
block bracket, which
is included with the
housing. Attach the
block to the bracket as
shown in the following
diagram. Use the M3
screws and washers
that are located in the
housing packet.
11. Attach the connector block assembly to the housing using
(1) 6-32x3/8" screw and star washer located in the housing
Machine screws (4)
packet.
Base Bracket
- 8 -