Polycom VSX Series Getting Started Manual page 15

© Polycom, Inc.
Depending on configuration capabilities, you may be able to control the
camera at the far site. If far-site camera control is allowed, you can create up
to 17 presets for the far-site camera. These presets are saved only for the
duration of the call. You may also be able to use presets that were created at
the far site to control the far-site camera.
To move the camera to a preset:
1. If a call is connected, press
or far-site camera or other video source.
2. Press a number on the remote control.
The camera moves to the preset position for the camera or other video
source.
To view your near-site presets (VSX set-top and component systems):
>>
Press Preset on the remote control.
Icons for presets 0-9 are shown on the screen. The colored icons indicate
stored camera positions, and the gray icons indicate available presets.
To store a preset:
1. If you are in a call, press
far-site camera or other video source.
2. If you selected a camera that supports electronic pan, tilt, and zoom,
you can adjust the camera's position:
Press the arrow buttons on the remote control to move the camera up,
down, to the left, or to the right.
Press Zoom to zoom the camera out or in.
3. Press Preset on the remote control.
4. Press and hold a number to store the preset position. To store a
double-digit preset, hold the second number down. Any existing preset
stored at the number you enter is replaced.
The system uses preset 0 as the default camera position.
Near or Far to choose a near-site
Near or Far to choose a near-site or
C W Y S
ONTROLLING HAT OU EE
11