Table of Contents
Advertisement
10-5 Description of the Item "Data output mode"
The parameter setting of the "Data output mode ( prt )" applies to the performance when the "Data
memory ( data )" parameter is set to " 2 " (to store the weighing data)and when the data is
transmitted using the RS-232C interface.
Key mode
When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs or
stores the weighing data and the display blinks one time.
Required setting
Auto print modes A and B
When the displayed value is stable and the conditions of "Auto print polarity", "Auto print difference"
and reference value are met, the balance outputs or stores the weighing data.
When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs or
stores the data and the display blinks one time. ,
Mode A: Example
Required setting
Mode B: Example
Required setting
Stream mode
The balance outputs the weighing data continuously regardless of the display condition. The display
does not blink in this mode. This mode is not available and the interval memory mode is used when
the "Data memory ( data )" parameter is set to " 2 " (to store the weighing data).
Example
Required setting
Caution
The balance may not transmit the data completely at the specified refresh rate, depending
on the baud rate or data added to the weighing data such as time, date and ID number.
dout
prt 0
"For weighing each time a sample is added (or removed), with
" ar-d " set to " 1 " (to adjust zero after the data is output)."
dout
prt 1
dout
ap-p
dout
ap-b
"For weighing while a sample is added."
dout
prt 2
dout
ap-p
dout
ap-b
"For monitoring data on a computer"
dout
prt 3
dout
data 0
ba5fnc
5pd
5if
bp5
38
Key mode
Auto print mode A (reference = zero)
Auto print polarity
Auto print difference
Auto print mode B (reference =
last stable value)
Auto print polarity
Auto print difference
Stream mode / Interval memory mode
Data memory function is not used.
Display refresh rate
Baud rate
Advertisement
Table of Contents
