Table of Contents
Advertisement
Display refresh rate ( 5pd )
The periodic time to refresh the display. This parameter influences "Baud rate", "Data output pause" and
the data output rate of "Stream mode".
Decimal point ( pnt )
The decimal point format can be selected.
Auto display-ON ( p-on )
When the AC adapter is plugged in, the display is automatically turned on without the ON:OFF
key operation, to display the weighing mode. Used when the balance is built into an automated
system. Half an hour warm up is necessary for accurate weighing.
Auto power-OFF（ p-off ）
This is a function to turn off only the display automatically when there is no operation made for
a certain amount of time (approximately 10 minutes) while the power is on.
Minimum display（ rng ）
When weighing with rough precision, the minimum display can be turned off without key
operation. This is useful when built into an automated system/
Buzzer（ beep ）
Select ON/OFF for the built-in buzzer that sounds when a key is operated or the status changes.
Tare value record（
After turning on the power supply, the display will not be automatically set to zero, and it will start
from the previous weighing value. This is useful when a hopper, etc. is attached to the weighing
pan and the power needs to be turned off while weighing discharge.
Backlight brightness（
Select the brightness of the backlight of the LCD display.
Impact shock detection（ i5d ）
Select ON/OFF for the Impact shock detection.
11-4
Description Of The Data Output
Download "Communication manual" from our website (http://www.aandd.jp/) and refer to it.
11-5 Description Of The Data Format
Download "Communication manual" from our website (http://www.aandd.jp/) and refer to it.
11-6
Output Example Of The Data Format
Download "Communication manual" from our website (http://www.aandd.jp/) and refer to it.
）
di5p-led
）
57
Advertisement
Table of Contents
