Table of Contents
Advertisement
Using the System
Recording
By default, the system is set to immediately record video from connected cameras in Continuous
Record Mode. Also, the system is set to record based on a certain Recording Schedule and
Record Program. The system uses ten Record Programs that you can customize to best fit your
needs. See "RECORD PROGRAM" on page 29.
Event Recording
The system includes three modes of event recording:
• Motion: The system records when motion is detected by the affected camera.
• Alarm: The system records when an alarm or sensor is triggered.
• Video Loss: The system records when a camera is disconnected or suffers video loss. The
system employs a pre-record function to capture video seconds before the video loss occurred.
You can customize the recording parameters (video quality, frames-per-second) of Event
Recording in the Record menu. See "RECORD SETUP" on page 29.
Event Recording is also useful in Search Mode, as you can filter recorded video data according
to event types. See "EVENT SEARCH" on page 18.
Recording Audio
The system can record up to 4 channels of audio. You must have audio enabled cameras (not
included) connected to the system in order to use this function. See "AUDIO RECORD" on
page 31.
14
Advertisement
Table of Contents
