Basic Setup - Digimerge DHU600 Series Instruction Manual

BASIC SETUP

1. CONNECT THE CAMERAS
a. Connect BNC cameras to the BNC IN
ports on the rear panel.
2. CONNECT A MONITOR
a. Connect up to three monitors to the
system using the DVI port, Monitor, or
Spot Out port (see figure 1.1).
VGA output requires a DVI to VGA
NOTE:
adapter (not included).
3. CONNECT THE ETHERNET
CABLE
a. Connect an Ethernet cable to the
Network port (LAN) on the rear panel of
system (see figure 1.2); connect the
other end of the Ethernet cable to an
empty LAN port on your router or switch
(not included) .
4. CONNECT THE POWER
CABLE
a. Connect the power cable to the DC 12V
port on the rear panel of the system;
connect the power adapter to an outlet,
power strip, or surge protector.
OPTIONAL: Mount the system to a rack
a. Use the included mounting kit to mount
the system to a rack.
2
BNC IN
Figure 1.0 Connect BNC cameras to the system (*16-channel
shown).
MONITOR
OUT
SPOT OUT
Figure 1.1 Connect to a DVI/VGA/CCTV monitor, or a TV. VGA
monitors require a DVI to VGA converter (not included).
Figure 1.2 Connect an RJ45 network cable into the
ETHERNET port.
Figure 1.4 OPTIONAL—Attach mounting kit for rack mounting
DVI OUT
Figure 1.3 Connect the power cable.