Powering On And Off - Polycom RealPresence Group Series User Manual

User's Guide for the Polycom RealPresence Group Series and the Polycom Touch Control

Powering On and Off

Polycom, Inc.
3 Wait until the status light on the battery turns green before removing it
from the port.
4 Insert the charged battery into the remote control.
The following figure illustrates these steps.
If you have a RealPresence Group 700 system, you can also recharge the
battery using the USB port on the front of the system.
Connect the power and power on the RealPresence Group System after you
have connected all of the equipment that you will use with it. Make sure that
the system is powered off before you connect devices to it.
It is important to note that Polycom RealPresence Group systems do not have
what you may think of as a power button—they have a power proximity sensor.
Instead of pressing an actual button that moves, you touch the sensor (or near
the sensor) that indicates power
To power on the RealPresence Group System, do one of the following:
• Press any button on the remote control or pick up the remote control to
wake up the system if it is asleep.
• Press on the remote control.
on the front of the system.
3