Allowing Video Display On The Web; Using The Virtual Remote Control - Polycom RealPresence Group Series User Manual

User's Guide for the Polycom RealPresence Group Series and the Polycom Touch Control

Allowing Video Display on the Web

Using the Virtual Remote Control

Polycom, Inc.
If your system administrator has allowed access to user settings, you can
choose whether to allow viewing of the room where the system is located or
video of calls in which the system participates. You can use the Polycom web
interface's Web Director to view the room or video.
Caution. The default setting is to not allow video display. Be sure to verify
whether your system administrator wants the setting to be changed.
To allow the display of video on the web:
1 From the Home screen, touch
2 Touch the RealPresence Group system tab.
3 Under Meetings, touch Allow Video Display on Web to enable the
option.
During normal operation, the Polycom Touch Control uses an IP connection to
communicate with the RealPresence Group system. If this connection is lost
for more than 2 minutes, you may see error messages on the RealPresence
Group system monitor and the Polycom Touch Control screen.
Once you are disconnected, you can use a virtual remote control on the
Polycom Touch Control to access the RealPresence Group system until the
connection is restored. The virtual remote control sends IR signals across the
room, so make sure the back of the Polycom Touch Control is facing the
RealPresence Group system camera.
.
29