Replacing The Microsd Card; Removing The Microsd Card - Mobotix Q24M User Manual

100
/164
Bayonet catch open
Carefully loosen
the rear casing
at the open-
ings on the side
with a screw-
driver before
removing it.
Push-push function: only
remove the MicroSD
card after first gen-
tly pushing it in
Q24M Camera Manual: Installation

2.10 Replacing The MicroSD Card

The camera must be taken down to remove, insert or replace a MicroSD card. To avoid
data loss, be sure to deactivate MicroSD card recording in the camera software and reboot
the MOBOTIX camera before removing the card.
A MicroSD card may only be removed from the camera after you have deactivated
Recording to SD Card and rebooted the camera. Failing to do so may lead to data loss!

2.10.1 Removing The MicroSD Card

1. Deactivate recording: Recording to MicroSD card must be deactivated (Admin Menu >
Storage on External File Server / Flash Device). If MicroSD card recording is still
active, deactivate recording and reboot the camera. Section 3.4, Micro SD Card
Recording, contains more information on this topic.
2. Remove the outer shell: Remove all four Allen screws
using the supplied Allen wrench and lift off the outer
shell.
3. Remove the connection cables: The connected cables
(patch cable, MiniUSB if present) must be removed from
the camera first by rotating and opening the bayonet
catch (see end of section 2.4.3).
4. Remove the back of the camera and take out the
MicroSD card: Remove the four screws from the back
plate using the supplied 2 mm Allen wrench and carefully
lift off the back plate. Gently push on the MicroSD card
in the card slot of the camera. The card will be released
from the slot and can then be removed from the camera.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Caution
www.mobotix.com • sales@mobotix.com