Procedure - Mobotix Q24M User Manual

92
/164
Q24M Camera Manual: Installation

2.8.3 Procedure

1. Remove the camera housing: Remove all four Allen
screws using the supplied Allen wrench and lift off the
outer shell. The screws and outer shell will be needed
again shortly.
2. Remove the camera mounting ring: Separate the black
mounting ring from the camera housing. This ring is not
required when mounting the camera to the Wall Mount.
3. Separate the bottom plate from the Wall Mount: The
bottom plate is used to hold the camera, and is only
attached and screwed into place during a later step.
4. Pass the camera cable up through the bottom of the
bottom plate: Ensure the orientation is correct. The
spring clips should be on the underside of the bottom
plate.
5. Snap the camera into place on the bottom plate:
Firmly push the camera into the Wall Mount. The plastic
spring clips will snap into place when the trapezoidal
elements on the rear of the camera housing exactly
match up with the corresponding openings on the Wall
Mount. Pay attention to the direction of the camera
(OBEN / TOP arrow pointing in the direction of the lon-
ger wall for ceiling installation in rectangular rooms).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com