Table of Contents
Advertisement
Installing the HPX-1600
Installation Location Notes
Care should also be taken to ensure that the system does not interfere with the normal use of the work space.
For example, on a table or work surface, ensure that the system does not interfere with the user's legs when
they are seated at the table. Even when the system is deployed in the up position, the mounting system and
shields occupy the entire space requirement below the table.
Step 2 - Cut the Hole In the Mounting Surface
Use the HPX-AC-TK (FG559-90) and a suitable router with ½" arbor to create the hole in the mounting
surface. FIG. 4 provides the hole cutout dimensions for reference:
FIG. 4
Hole Cutout Dimensions
1.
Carefully measure the tabletop or other mounting surface to locate the desired position of the Hydraport
unit.
2.
Apply the included double-sided tape mounting strips to the bottom surface of the HPX-AC-T router
template, making sure that the rounded edges of the mounting strips protrude slightly beyond the edges of
the template (see FIG. 5).
3.
Use the alignment marks scribed on the template to align the template properly on the mounting surface
(FIG. 5).
FIG. 5
HPX-AC-T Router Template
8
The Hydraport system requires a mounting surface from 19mm (.75in) to 50mm (2.0in) thick.
The Hydraport system requires at least 383mm x 293mm x 159mm (zzin x xxin x yyin) of space
below the mounting surface.
If the system is to be mounted within a column, pillar or other enclosed space below the mounting
surface, please note that final assembly and termination will require the installer to have access to
this space below the mounting surface.
Double-sided mounting strips
Double-sided mounting strips
Alignment Marks
HPX-1600 Retractable Connection Port
Advertisement
Table of Contents
