Step 10 - Install Shields - AMX HPX-1600 Installation Manual

Installing the HPX-1600

Step 10 - Install Shields

1.
Secure the two shields to each other using the 8 supplied screws.
Ensure that any fixed cables pass through the assembled shield appropriately.
2.
Snap the assembled shield onto the lower portion of the mounting sleeve.
3.
Install the four additional mounting screws into the top of the shield to secure the shield to the mounting
sleeve (FIG. 22).
4 screws secure the top
of the Shields to the
Mounting Sleeve
8 screws (4 on each side)
secure the two Shields to
FIG. 22 Installing the Shields
24
each other
Shields
HPX-1600 Retractable Connection Port