Step 7 - Install The System Into The Mounting Surface - AMX HPX-1600 Installation Manual

Installing the HPX-1600

Step 7 - Install the System Into the Mounting Surface

Turn the system over and install the unit into the cutout in the mounting surface (FIG. 18).
Aluminum Frame (bottom)
FIG. 18 Completed Assembly Latched In the Closed Position


20
Mounting Surface
HPX-1600 Chassis
Spring Lift Assembly
Make sure that all cables from the backside terminations pass through the cutout.
Note that any fixed cables should already be passed through both the mounting surface and
retaining ring (see the Step 3 - Prepare the Terminations section on page 10).
Mounting Sleeve
Module Faceplate
Spring Lift Assembly
HPX-1600 Retractable Connection Port