Step 5 - Install The Bottom Cover - AMX HPX-1600 Installation Manual

Step 5 - Install the Bottom Cover

Once all of the desired modules are installed, complete each face of the system with blank modules.
At least 3M (3") of blank modules will be used at the bottom of the system to correspond to that portion of the
system that is always below the mounting surface, even when the system is deployed in the up position
(FIG. 12).
The 10A Circuit Breaker provided in HPX-PAK-xx can be used to occupy one of these positions.
If a Stop Block (FG559-01) is used to limit the travel of the system in the Up position, 2M (2") of Blank
modules will be used above the Stop Block and below the mounting surface.
The 10A Circuit Breaker provided in HPX-PAK-xx can be used to occupy one of these positions. .
Mounting Surface
10A Circuit
Breaker Module
FIG. 12
Install Blank Modules at the Bottom of the System
Once each face of the system is fully occupied with active or blank modules, install the bottom cover.
1.
Ensure each AC power module is connected to the power inlet assembly and that the circuit breaker is
also connected to the power inlet assembly (FIG. 13).
HPX-1600 Retractable Connection Port
Installing the HPX-1600
Mounting Surface
Stop Block
(FG559-01)
Blank Module(s)
15