Step 6 - Install The Lift Spring Assemblies - AMX HPX-1600 Installation Manual

Installing the HPX-1600

Step 6 - Install the Lift Spring Assemblies

ATTENTION: If modules have been installed in more than 50% of the available space, the performance of the
HPX-1600 retract mechanism may benefit from the installation of the optional accessory HPX-AC-HSP
(FG559-42). See the installation guide for HPX-AC-HSP for further details.
After the bottom cover is fully secure and the exiting cables are secured:
1.
Clip both lift spring assemblies onto the mounting sleeve.
2.
Ensure the lift spring assembly is oriented properly (FIG. 16).
FIG. 16 Lift spring assembly clipped to main sleeve
3.
Unlatch the sliding frame and mounting sleeve so the sleeve is free to slide relative to the frame.
4.
Slide the mounting sleeve so that it is nearest to the bottom cover.
5.
Take hold of the body of one lift spring assembly and pull it firmly up so that it can be snapped into the
provided slot in the bottom cover (FIG. 17).
18
Lift Spring Assembly
Clip
Base Assembly
(bottom of HPX-1600
Mounting Sleeve
HPX-1600 Retractable Connection Port