Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual page 55

INSTALLATION OF CAR ANCHOR FITTING
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE BOLT IS NOT THE
CORRECT LENGTH THE CAR MANUFACTURER'S HAND BOOK
CAN PROVIDE ADVICE ON THE CORRECT LENGTH BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND
METAL OR TO WOOD, OR SYNTHETIC STRUCTURES. WHEN
DRILLING 9 MM HOLE DO NOT DRILL THROUGH FUEL LINES,
FUEL TANKS, ELECTRICAL WIRING, OR RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM SHARP
CORNERS AND EDGES. THE ANCHOR FITTING MUST BE USED
ONLY AS DESCRIBED ABOVE. IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
CAR INSTALLATION ACCESSORIES
(From retailers of BRITAX Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
Re-order no: 0035 (length 300mm) or
0036 (length 600mm)
GATED 3-BAR SLIDE (Locking clip): For converting lap-sash seatbelt to lap belt, and to obtain a better
fit to the car where the fitted lock-off may not be suitable. Most cars will not need this, Re-order no:
0215.
Note: Marking on
the top of a Grade 5
Bolt.
Front of Vehicle
200mm
min.
Fig.3.
Centre line of
seating position
55