Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual page 16

HOW TO SETUP
F. Refit the harness buckle through the seat pad and
fit the seat pad around the push button adjuster
moulding. Refit the seat pad by connecting with
the seat cover along the seat surface and up the
backrest. For smaller babies replace the Infant
Safety Cushion™ Insert. Do not use the insert if
the child's shoulders reach the Lower Shoulder
Height Marker, remove the insert for longer use
whilst still rear facing. See page 23 for advice on
positioning the shoulder straps and headrest.
G. Align the restraint centrally to the chosen seating
position. Pull sash portion of seatbelt until all
slack is removed from lap portion of seatbelt.
Adjust seatbelt to hold the restraint firmly against
the vehicle seat back. For retractor seatbelts,
allow excess belt to feed back into retractor. Lock
the rear facing seatbelt lock-off to prevent the
seatbelt slackening.
If placing the restraint in a seating position with
a lap only seatbelt, tighten the seatbelt so as to
hold the restraint firmly against the vehicle seat
back.
On the opposite side to the seatbelt buckle,
only pass the lap portion of the belt through the
lock-off and lock in place (optional).
16
Rear facing
seatbelt
lock-off
On the car seatbelt buckle side, pass both lap and
sash seatbelt through the lock-off and lock in place