Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual page 34

HOW TO SETUP
J. Fully lengthen seatbelt. Thread the seatbelt into forward facing seatbelt path (yellow marker) as
shown below, ensuring that the seatbelt is behind the harness straps and that the lap part of the
seatbelt is below the hook as shown below, on each side.
NOTE: Seatbelt extenders should not be used. If the seatbelt is not long enough to secure the child
restraint. If they are used then the buckle tongue must not enter the seating zone.
K. Engage seatbelt buckle and tongue. Firmly push down on the seat with knee or hand, whilst pulling
the sash belt with the other hand to tighten the lap portion of the car's seatbelt. Feed the sash
portion into the lock-off and whilst holding the belt tension, press the lock-off lever to clamp the
sash belt. For inertia/retractable seatbelts, allow excess belt to feed back into retractor.
L. If using just a lap seatbelt, thread the seatbelt through the back of the seat following the belt path.
Keep the belt under the hook on each side. Then engage the buckle and tighten the seatbelt so the
restraint is held firmly against the car's back.
Engage
Seatbelt
tongue
Buckle
34
Push down on the seat
Seatbelt
lock-off lever
Ensure lap part of
seatbelt is below the
hooks
Lap Seatbelt
Hook
Pull sash portion of seatbelt
through the lock-off to remove
Yellow
FORWARD-
FACING BELT
PATH
slack
label